SCPRO 4A is an installation amplifier inside SCPRO Series, with attractive features which allow to make a big number of installations and diversified control possibilities.
It has a sensitivity adjustment from -infin to 0dB and two operating modes: Bridge (normal mode) and Parallel (for additional configurations). The shutdown function allows to enable the standby mode remotely.
| SCPRO 4A |
Output Power (Bridge) | 1 x 40W 8 Ohm (24Vdc) |
Output Power (Parallel) | 2 x 20W 4 Ohm (24Vdc) |
Sensitivity Vrms | 225mVrms(bal) / 450mV(unbal); sens 0dB |
Output monitor Level Vrms | 890 mVrms (nominal input line) |
Recommended Power Supply | 24 Vdc - 1.7A |
THD+N | <0.08% |
Function modes | Parallel / Bridge |
Gain | 20dB |
Minimum Load | Parallel 4 Ohm / Bridge 8 Ohm |
Dimensions (WxHxD) | 99x30x89 mm |
Weight | 240 g |
|
SC PRO 4A |
Terminal block |
14 pin Euroblock connector |
Sensitivity |
Knob from -infin to 0dB |
Function mode selector |
Parallel / Bridge |
Input |
Bal. 3 pin (IN+, IN-,
GND) / Unbal. 2 pin (IN+, GND) |
Shutdown function |
1 pin (SD_TPA) + 1 pin GND |
Monitor Output |
Bal. 3 pin (Out+,
Out-, GND) / Unbal. (Out+, GND) |
Speaker 1 |
2 pin (+, -) |
Speaker 2 |
2 pin (+, - ) |
Power |
2 pin (24 VDC, GND) |
Manual | SCPRO_SERIES_MANUAL | ![]() | Download |