Ethernet (OSC) programmable wall-mounted controller for BlueLine. PoE
We do not have the quantity requested in stock
BLC 1
Wall-mount controller. Connection to any receiver through Cat5 cables (Not Ethernet). Possibility to control volume and to select input source. Auxiliary input for local source connection. Dimensions: 85 x 85 x 40 mm Weight: 700 g
Modular central unit of Blueline Digital. Composed of: Main supply unit (BL PSU). Two channel Ethernet streamer (BLS 2M) with 8 GPIO and contacts to communicate with the alarm system. 3U fully modular rack chassis. Possibility to add BLS modules (each module adds two audio channels in the network) and other modules (e.g. solid-state players, communication ports, etc.) to adapt Blueline Digital to the needs of the installation.
Two channel Ethernet streamer. 8 GPIO available to transmit its state over the network. It transmits/receives audio and GPIO contact states. One input is available to enter an alarm condition.
GPI features:
- As inputs, they work as inner PULL-UP resistor switching on when the contact pass to GND. In this case, the device send two types of messages:
· A prefixed message for those devices registered into the system.
· A message block, which can be OSC commands or a group of data, which content and IP address destination are configurable by users.
- It is possible to send several configurable messages to different devices because each message has attached a specific IP destination address. Messages are generated in activation as well as deactivation processes.
GPIO features:
- As output, the device receives a prefixed GPIO through an OSC command with the information about the selected port and its status (activated or deactivated). Acting as GPO, the unit operates in OPEN COLLECTOR
Ethernet wall-mounted for BlueLine or Digiline. 5 V DC.
We do not have the quantity requested in stock
WNC 1
Wall-mount Ethernet controller.
Compatible with WorkCAD Designer.
Intuitive control of audio of a determined output.
Possibility to control output volume.
Select output source. Weight: 700 g
Wall-mount controller for any GPI interface, like Digiline series. Composed of buttons that switch on/off contacts. Possibility to set up a configuration using WorkCAD Designer (e.g mute al channels, fade, change audio source configuration for a determined output, etc.) and assign it one of the buttons of WGC 1. Set of stickers to name each button. Easy-to-use and economical. Dimensions: 85 x 85 x 40 mm Weight: 700 g